94 lt1 cam

[camarojoe12]

Just got the block back from the machine shop.. I'm reassembling the bottom end myself. I hear mixed opinions on clocking the cam bearings. Any input on this would be great. Trying to figure out the oiling hole locations. Thanks

[KLAB]

order this good info: http://www.amazon.com/Rebuild-Small-Block-Chevy-Engines-Hp1393/dp/1557883939

[frankzlt1]

Im going to get that book

[camarojoe12]

Recommendations on break in oil / procedure ?

[irockidz28]

idk how often 98 hoe is on here but he just did his 95 last year. did it all hime self too.

[irockidz28]

i think he had the machine shop install the cam bearings now that i think of it tho

[98 hoe]

I had machine shop magnaflaux it and install cam bearings. I just used regular oil let it run on idle for about 20 min then idle up about 1500. Double checked everything test drove it normal. And changed oil at 500-1000 miles.

[camarojoe12]

Thanks. For the reply I will just use regular 530 bulk oil for starters then. Just wasn't sure whether or not I needed an additive or anything.

[84ta406]

I like adding the zinc just for safety.. whats a couple bux?

[98 hoe]

If it where flat tappet cam I would but u have a roller so either way. Also al my parts where used besides the bearings and rings.