Thanks Dawg! I'll either give them a call or stop in and talk to them.

These EBay ones are not too bad. They just need a little work to make them perfect.

For the COPO car I picked up real nice repops from TMI Products. I compared them to the original panels and the differences are very small. The COPO car is a clone car loaded with repop stuff anyway.

The Z will end up with very little repop.

NOS dash panel came in today. It looked good but had a little rust on it and is a little bent in one spot. 43 years old though so overall it is A-OK.
http://i1126.photobucket.com/albums/...-51-47_711.jpg

but the original GM box it was in had a very hard life. LOL.
http://i1126.photobucket.com/albums/...2-02-16_70.jpg

I dropped it off at Labrecque Autocraft and Mike has the Z in primer.
http://i1126.photobucket.com/albums/...-43-35_605.jpg

and I verified that the old door panels that were on the car have the same part number as the ones I picked up on EBay "Seaman 7793352"
http://i1126.photobucket.com/albums/...-37-17_261.jpg

There was also a 69 Firebird there that Mike restored with a frame off restoration a while back and the guy wanted a few changes. Sweet. This guy should join the club!!!!
http://i1126.photobucket.com/albums/...-55-50_464.jpg
http://i1126.photobucket.com/albums/...-53-13_515.jpg

Hell Yeah that car is Sweet!!!!!!

well if we just had New england F body business cards made up we could leave one for them?????

They are made but nobody has any because Pizzafuck can never remember to bring them when we have meets!!!!!!!!!!!!!

What do the cards say?

I __________ hereby cordially invite you (the owner of a super Fbody) to join the awesomest club in the New England region forewith known as the the North East FBody Association: www.northeast-fbodyassn.com.

Join or die. HA. HA. HA.

http://www.ultimateflags.com/images/...r-die-flag.jpg

join or die sounds like a good plan!!!!! Go All New Hampshire on there ass!!!!

ya strait up at to the point

Z/28 subframe came back from being acid dipped
http://img.photobucket.com/albums/v2...-02-44_144.jpg

Mike removed the oil coating, sand blasted the weld seams, prepped and
used a black epoxy primer on it.
http://img.photobucket.com/albums/v2...8/Img_5601.jpg

the restoration is moving along
http://img.photobucket.com/albums/v2...8/Img_5602.jpg

Looking good David!


A $1,000,000 later!!!!!!!!!!!! lol