You have drag springs on it right? You could try drag shocks too, something like QA1s. Spendy I know.

Drive on lift??????????? I wonder where one of those are?????????????? Any idea Captain Fuckface??????????????????????????????











You were very close to one last fucking night!!!!!!!!!!!!!!! :madfu: :madfu: :madfu:

you dont need a drive on to do pinion angle. measure the angle of the driveshaft and make the pinion 2-3 degrees less. its not a leaf spring or 4 link car, the pinion angle will remain the same through a wide range of motion.

you should never adjust pinion angle wen the suspension is unloaded.

I got some Comp engineering 3 ways, if you wanna try em?

DeCarbons have really poor damping characteristics. If you fix your pinion angle, get some Bilstiens. After that I'm not sure...

only thing that makes me think its not the shocks is the come factory. and if that was my issue then a factory car/setup would hop and they dont. correct me if im wrong?

Car doesn't make ~400rwtq from the factory though

damn right they dont have good dampening my car slams the rear bump stops launching at the track!

I have stock decarbons also fuck a bilstien if you drag race bilstien has no place on your car. Decarbons have been on many 9 second cars