Power Window Motor Replacement?
 

Anyone ever replaced a window motor by just removing the motor alone?
ShoeBox Window Motor Replacement
YouTube Repair Video

I've already drilled the door panel and can see the rivets, I've ordered the new motor (AutoZone), and plan to complete the job this weekend.

Right now my biggest concern is how easy is it to re-align the motor?:dunce:

It's not bad at all did both sides just take your time because there will be some swearing going on its crammed to get your arms in there but if its held up with a c clamp aligning it back up will be simple

I said screw it and replaced the whole track and motor.

Not worth the extra $120 and disassembling the entire inside door panel (like 2 to 3 hours work for that alone):sick2:

Got it all completed this afternoon, in a little less than 2 hours with a bunch of diddle daddling....

1 - Used a 2x4 (which fit perfectly in the top center hole) to support the window (seen in the shoebox photos), the motor bolted back in without any real issue:pfff: But I did have to remove the door panel 3 more times to adjust wiring and even fix broken wires on my relays (Did the Relay mod last year to hopefully avoid the motor replacement)

2 - Aligning the motor was actually simple using a small screw driver to support it through the top hole for alignment, and tightening the bottom bolts first.

3 - A Finger Rachet also helps for easy tightening of the nuts on the backside.

4 - Loctite and nylon lock nuts to ensure it stays in place.

My old motor was so bad it would stop in 1 second even out of the car with nothing attached to the motor at all.

All in all not a bad job at all, if really motivated it could be done in 30 to 45 minutes.

I've done this numerous times. well worth drilling those 3 holes in the fiberglass. did it the hard way the first time learned this method and have used it ever since. The only issue of concern is making sure the regulator is chocked up so the window won't fall after drilling out the old motor, as well as making sure the new motor gears line up where you need them. If you are off by even one tooth the window either wont go up tight or it will be a little too tight and the door will flex a bit.

and when the new motor dies (yes when not if) it makes it that much easier to replace since you won't need to drill anything.

yea i did both sides in about an hour with the drill method.