New Stuff!
 

http://i163.photobucket.com/albums/t...project056.jpg
valve covers i have had for a few months

http://i163.photobucket.com/albums/t...project055.jpg
edelbrock shorty headers with y-pipe

http://i163.photobucket.com/albums/t...project047.jpg
stock

http://i163.photobucket.com/albums/t...project050.jpg

http://i163.photobucket.com/albums/t...project049.jpg

http://i163.photobucket.com/albums/t...project051.jpg

http://i163.photobucket.com/albums/t...project052.jpg
and leave it to the last one to break

valve covers look nasty, same with the headers. good luck with the install. those motors are not fun to work on.

that should help ya breathe a little better.

Good luck Ben! Have fun!

looks like a ton of fun. should sound good when done. What r ya gonna do about that broken bolt?

i have got it soaking in PB blaster now when i get the chance to work on it probably tomorrow there is enough to get a pair of vise grips on it so ill try that maybe a little heat if i have too we will see what happens

weld a nut to it.....

What he said if you can, but try a torch first. I broke a bolt off in the block removing the thermostat housing from my Escort, just a little heating up and it came out with vise grips.

heat it up with a torch then cool it with that rust cracker cold spray and it should come right out