North East F-Body Association

North East F-Body Association (http://www.northeastf-bodyassn.com/index.php)
-   Fourth Generation (http://www.northeastf-bodyassn.com/forumdisplay.php?f=16)
-   -   Need to replace my A/C compressor (http://www.northeastf-bodyassn.com/showthread.php?t=1575)

Formula413 08-04-2011 02:28 AM

Yeah the tensioner seems perfectly fine. If it was the tensioner I would think it would make the noise with the stock compressor on there as well, but it doesn't. Only the aftermarket compressors. Anyone got an LT1 tensioner laying around I could try just to rule it out?

Grovlet 08-04-2011 06:02 PM

Is there a way to shim/adjust the pulley on the new compressors? I know you can sometimes get just the clutch assembly itself, so I would think there's an adjustment to account for that.

Essentially I wonder if the new one's are not adjusted and the pulley is slightly out of line with where it needs to be, but original is of course properly adjusted?

ILuvPizzaTimes10 08-04-2011 06:07 PM

Or the aftermarket compressor has a slightly smaller diameter pully and you will need a smaller belt. Does i t sound like belt chirp or metal on clutch material noise?

Formula413 08-04-2011 06:24 PM

I didn't see any way of adjusting anything. As for the noise it just sounds like a squeaking pulley. It gets a lot quiter once the engine is warmed up.

ILuvPizzaTimes10 08-05-2011 08:50 PM

belt is probably too short because the pulley on the A/C is a bit smaller then it should be.

Formula413 08-05-2011 09:11 PM

1 Attachment(s)
If the pulley was smaller that would make the belt too long. Here's a pic of both, I could take measurements but they look pretty close.

ILuvPizzaTimes10 08-05-2011 10:50 PM

Looks smaller too me. It squiks wether you are using the ac or not? If so check. Belt length.

Formula413 08-05-2011 11:11 PM

Yeah like I said I haven't even charged the AC yet much less turned it on. I'll try putting the old serp belt back on just for the heck of it. You don't have a tensioner lying around do you?

ls6monte 08-06-2011 12:57 AM

I think the pulley is the same on both. It looks smaller because the clutch on the gm compressor is so much bigger.

fasta**z28 08-06-2011 12:58 AM

got a used one i took off the lt1 over the winter u want it free ? and a tensioner


All times are GMT. The time now is 09:19 PM.

Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.