North East F-Body Association

North East F-Body Association (http://www.northeastf-bodyassn.com/index.php)
-   Fourth Generation (http://www.northeastf-bodyassn.com/forumdisplay.php?f=16)
-   -   Picked up another z28 with auto this time need help!! (http://www.northeastf-bodyassn.com/showthread.php?t=3960)

fasta**z28 04-01-2012 03:18 AM

Picked up another z28 with auto this time need help!!
 
hey everyone !! i recently picked up a 96 z28 auto with 90k , well it wont shift out of 2nd so no drive and overdrive i found a broken tps , replaced it no change. i dropped the tranny pan today emptied all fluid from pan and lines going to cooler and changed filter , gasket and both a and b shift solenoids . Now when driving only at wot it will shift from 2nd to drive somtimes? so what im asking is all of you with 4l60e can u give me any ideas on whats going on ? asr switch isnt working also? please ant input would be great !! thanks much appretiated.
joe

My84Z 04-01-2012 03:54 AM

Usually d and od are the first to go in these trans does it go in and just rev or not shift at all?

DemonWithin99 04-01-2012 04:16 AM

does it have 2nd gear start? could be that. or it's time to replace it.

fasta**z28 04-01-2012 02:12 PM

Yea it pulls and shifts great in 1 and 2 then when it goes to drive it just free revs unless i go wot and let off the gas it will shift to third sometimes!! could it be the clutch pack 3/4
thanks for the replies

ILuvPizzaTimes10 04-01-2012 02:40 PM

sounds like someone swapped the tranny out for a 1994 tranny? thats what they do. they wont shift. unless WOT and its only from pressures and not the computer telling it to do so. see if you can get to the plastic tag. the 2 letter code tells you the year and month.

irockidz28 04-01-2012 02:42 PM

With a 94 trans drive would be reverse and reverse would be drive. That's what happened when I tried it

fasta**z28 04-01-2012 03:16 PM

hmmm i will check the tag in a couple mins , but i mean it pulls good in reverse shifts perfect in 1,2 and wont shift manually into drive or overdrive will shift only somtimes mashing it and letting off , so Irockid your saying that i should move the shift linkage ? just confused!! could i still be low on fluid? i mean i pulled the pan and refilled with 5 quarts but it was real low when i got the car the other day so coukld it just need more ?

ZFreie 04-01-2012 03:23 PM

Sounds like a toast 3-4, same thing the trans in my car did to the guy before when he had it rebuilt lol

DemonWithin99 04-01-2012 03:56 PM

^I'd agree with that.

fasta**z28 04-01-2012 05:36 PM

ok so i put 2 more quarts in and just took this thing out on the high way went wot through all gears hesitated to shift into overdrive but slammed through 123 no problem but i did i reached about 120 real quick unsure if the vss isnt correct or what also when i came to a complete stop at the end of the highway fucking car just died . checked the alt no voltage seems to be gone , now would a bad alt with either low or really high volts mess the tranny functions up , because the shift solinoids are controlled by voltage?

irockidz28 04-01-2012 11:58 PM

Quote:

Originally Posted by fasta**z28 (Post 65499)
hmmm i will check the tag in a couple mins , but i mean it pulls good in reverse shifts perfect in 1,2 and wont shift manually into drive or overdrive will shift only somtimes mashing it and letting off , so Irockid your saying that i should move the shift linkage ? just confused!! could i still be low on fluid? i mean i pulled the pan and refilled with 5 quarts but it was real low when i got the car the other day so coukld it just need more ?

No I had to swap the valve body/ solenoids/ wiring from the original 95 trans to the 94 I don't think that that is your problem

My84Z 04-02-2012 12:32 AM

No but being 2qts low will not let it shift and probably will kill the clutches soon

ILuvPizzaTimes10 04-02-2012 01:38 PM

yeah was it low on the stick and you added it? or did you just over fill it?

fasta**z28 04-02-2012 01:48 PM

Pizza yes when i got the car it was very low on fluid so i dropped the pan repaced the solenoids and checked the band i could see and anything i could test and poke around wile off!!! so i then put about 6 quarts since in it and still seems pretty low. also found a broken ground bolt just hanging there with straps rusted to the break on the bolt, so i cleaned all the grounds and also thru a new alternator on since the other one was toasted.. i am going to go drive the thing in a couple mins i will let you guys no whats comes out of this , THANKS FOR THE REPLIES EVERYONE!!!

KLAB 04-02-2012 03:58 PM

sounds like how my car shifted with the 94 pcm in my 95 car.

pics of the car or ban and do you still have the 3rd gen?

fasta**z28 04-02-2012 06:38 PM

2 Attachment(s)
[ATTACH]Attachment 1056[/ATTACH]

there yah go ill post more when i clean her up a lil, Klab yea i got the third gen still ive had it since i was 14 im pushing 26 now lol why are u interested looking to sell it to someone that wikl take care of it and not just part it out!!

fasta**z28 04-02-2012 09:00 PM

K so i took it out on a drive with everything ive done and still no change just got a shit ton worse no i have pinging so i hooked up a scanner to it and im pulling these codes scanning the tranny and motor seprate

p0335 ckp p0336 ckp , p1371- opti harness?, p1661 malfunction with interior lighting ?

would any of these throw my car off really that bad?
do i trace wires or just go buy a crank sensor? any imput?

Formula413 04-02-2012 09:10 PM

Quote:

Originally Posted by fasta**z28 (Post 65590)
p1661 malfunction with interior lighting ?

Might try plugging back in the lights I unplugged the other day LOL

I still want to know what is going on with that Opti harness and why someone hacked into it like that, and that wire on the coil too

fasta**z28 04-02-2012 09:21 PM

yea alex im so stumped on this bought another persons headach maybe thats y it sat for 6 years lol just going thru everything and cleaning as i go shits discusting feel like punching the kid in the face and saying this is how u took care of ur fbody damn it. so do i replace opti first or ckps ? grrrr

Formula413 04-02-2012 09:59 PM

Post up some pics of the wiring that was monkeyed with and see if anyone can figure out what it might have been for.

fasta**z28 04-02-2012 10:33 PM

ok now im going nut this orange and black striped wire is this the nuetral safty switch it is twisted wit a blue wire looks like its going to a ground but the orange and black is coming from under steering column to my opti low res red/black wire not normal? is thiis why my tranny wont shift if it is a nuetral safty?

ILuvPizzaTimes10 04-03-2012 12:39 AM

sounds like you bought a mess. i wouldnt drive it at all untill you figure all that out. 9 times out of 10 if its the opti it runs like shit, and wont effect anything but the timing events. ckp sensor is only for miss fire and does no other function. so that wont cause anything like you describe. id say go threw a proper diagram wire by wire that has been fucked with and put them all back were they belong/in a not fucked with state. and go from there. you got some Long weekends on your hands. im willing to bet all the fucked with shit was from a remote starter or something along those lines. maybe an alarm that kills the car. and some one put it in all jacked. good luck!

Formula413 04-03-2012 01:28 AM

IDK what the fuck this person did. There was a wire spliced into the opti harness that goes over to part of the harness right at the driver's side edge of the engine bay. Then there's a wire spliced in at the ignition coil that goes down under the passenger side manifold somewhere. They also had the fans set to come on with key on by running household wire from the fuse box down to the fans. Ruh-tarded.

Camaro9969 04-04-2012 06:37 PM

That's obnoxious someone messed with the wiring like that. I say get a new harness might be worth it than dealing with his shit.

BigMac76 04-04-2012 09:21 PM

Quote:

Originally Posted by Formula413 (Post 65633)
...also had the fans set to come on with key on by running household wire from the fuse box down to the fans. Ruh-tarded.

OMG hahaha, I wonder if they sold a buddy of mine a 87 Chevy 1500 about 5 yrs ago. Dude had half of the gauges and 90% of the fuse panel wired up with 12-2 Romex. Took almost a month of weekends just to get it back right, and that was only a carbed engine because everything was so hacked up in there.

KB93z28 04-04-2012 11:01 PM

Shoulda bought my car haha

fasta**z28 04-05-2012 12:11 AM

Quote:

Originally Posted by KB93z28 (Post 65766)
Shoulda bought my car haha

yea i bought it for 450.00 with the issues couldn't pass it up thought it be somthing dumb and def didn't want him too jyard it evrything good except trans and wiring.

so spent all day and nite yesterday and most of today unhooking and rehooking the whole engine end of the harness to the pcm , man what a mess had to get all the nasty old burnt crumbly loom off and then all old rotted tape and half ass wrap jobs they did cleaning every inch i went ? What i found is not only a hack in to the opti harness low res side and almost 25% of the wires where nicked and bare rubbing on each other all the way thru the harness like a rat chewed it or somthing. So i repined the main wires that where damaged thru out the harness. then sifted thru every wire and cleaned the loom up , almost every injector wire was destroyed too? so the engine bay is totaly cleaned up and i no its good. car starts perfect and throwing no more p1371 but am throwing the ckp still because for some reason my 96 dont got a crank sensor ha ha go figure them fuckers. So i plan to continue the search with the trans wiring and under dash wiring this week.also went thru all vacumes and replaced all what a head ache but patience is the key ive learned with the other!

ILuvPizzaTimes10 04-05-2012 12:18 AM

p1371 is low res from opti. your crank sensor should be in the bottom drivers side of the timing cover. if its not there??? you have a 1995 or worse 1993-1994 timing cover and need the proper cover to get the crank sensor in there or have it tuned out. there really is no telling what it will do if you dont have a low res pulse and your also missing the ckp input. take care of that then move on id say.

Formula413 04-05-2012 12:49 AM

If this car really has the wrong timing cover for some reason could he tap it for a CPS?

And what does low res pulse usually indicate?

ILuvPizzaTimes10 04-05-2012 01:01 AM

low res is usually opti harness related. but sometimes can be the opti itself. usually you see the high res go bad first. and as far as the cover goes its a completely different cover. and he will also need to add the reluctor behind the cover.

Formula413 04-05-2012 01:05 AM

Well the harness was definitely fucked with so that's a possibility. As for the crank sensor I don't know what to think.

fasta**z28 04-05-2012 01:13 PM

Haha yea damn motor was either replaced or they thru a diff cover on it.
I think the motor was replaced to be honest. the ckps plug is there its just zip tied to the k member. this is what id need to do, get the ckp sensor, timing cover, reluctor, crank gear key and crank hub from a 96 or tune it out i say i tune it out lol!!!
another thing -knock sensor resistance (96 is 100Kohms, this motor is reading 4.5Kohms)=95 earlier? do i need a 96 knock sensor?

-vacuum switch for EVAP purge detection (96 only) right im missing this two
is there a way to see what year my pcm is maybe they swapped that too?
WTF WTF WTF

ILuvPizzaTimes10 04-05-2012 01:45 PM

if you have an ckp code its still a 1996 ecm. 1995 and back didnt have them. i still say take care of the pending codes with the opti and move onto the next thing. and wen your done have a madz tune done. probably the cheapest way to go as far as tune. and they do a Way better job at mail order then PCM FOR LESS!!

fasta**z28 04-06-2012 06:18 PM

Ok so i finished tracing the wires thru out the car and i finally found out where these orange/black and blue wires go. They are from a box under the dash called a omega sr 7k remote start unlock keyless entry crap . they tied it in to the opti harness when it was supposed to go to battery pos and blue is for a hood switch? other than that all is fine but still no shift in tranny? speedo is off by 15 mph and gage lights dont work also have check gages light on ?


All times are GMT. The time now is 05:16 PM.

Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.