North East F-Body Association

North East F-Body Association (http://www.northeastf-bodyassn.com/index.php)
-   Lounge (http://www.northeastf-bodyassn.com/forumdisplay.php?f=2)
-   -   Weird AC issue on my Civic (http://www.northeastf-bodyassn.com/showthread.php?t=4306)

Formula413 07-12-2012 04:27 PM

Weird AC issue on my Civic
 
I had an issue with the air conditioner on my Civic when I went on my trip, trying to figure out what the deal is. Four days into my trip the AC became intermittent and then stopped working altogether (not fun when you're driving through the southwest). But I figured out that it would work when the engine was not under load, IE idling or coasting.

Stopped at a garage in Texas to have it looked at, the guy said the low side pressure was low but when he tried to add refrigerant it all went to the high side, and he thought the compressor might be going out.

Next day I had a Honda dealer in Albuquerque look at it, they said the system was actually overcharged (obviously from the last guy trying to add refrigerant) and they said that they thought the problem was that the AC was set to economy mode. Never mind that is has always been set to economy mode ever since I've owned the car and always worked fine. They evacuated and recharged the system and pronounced it good, which it was for about 15 minutes. So much for the dealer having all the answers.

Skip ahead a few weeks, I'm in the midwest in the middle of an oppressive heat wave. One day in Iowa I try turning on the AC just to see what happens, and sure enough it's working, load or no load, and has been working fine since.

The only variable I can see between when it worked and when it didn't is the elevation. Western Oklahoma and the Texas panhandle, which is where it started having problems, is also where the elevation starts to increase heading towards the continental divide. From there much of the trip was at elevations of 4,000ft-7,000ft or more, except along the west coast where it was cooler and I didn't try to use the AC. And eastern Nebraska and Iowa is where it dropped back down to about the 1,000ft range. Could elevation have anything to do with the AC not working? Or is it just a coincidence?

ILuvPizzaTimes10 07-12-2012 06:18 PM

Orfice tube or reciever dryer are plugged. Causing a high side pressure and the low side to drop off. The refirgerant isn't circulating well. Have it vacced and change both if your system has them. And look for small aluminum filings. If there are any the compressor might be going as well. Causing the blocked filters.

84ta406 07-12-2012 06:25 PM

Agreed with pizza, we had a similar problem on a motorhome here

Formula413 07-12-2012 06:29 PM

I thought that a plugged orifice tube or expansion valve would make sense, I just don't know why it started working again, unless whatever was plugging it moved. I can see the dryer but I'm not sure where the expansion valve/orifice tube is, the lines go into the firewall so unfortunately it's probably behind the dash.

98 hoe 07-14-2012 12:27 AM

usually they r in the line look for crimp marks right after a connection in the ac line thats where the orifice tube is. i agree with pizza as well. do u know if that uses vaccum solienoids or electric ones to opperate the hvac temp doors?

Formula413 07-14-2012 03:27 AM

I looked up parts for it and it uses an expansion valve. It's hard to tell from the diagram but if it's not in the engine bay it must be behind the firewall.

As for the blend door control I'm not sure. Had all that stuff out to install the stereo but I don't remember what was back there. It's climate control is that tells you anything.

ILuvPizzaTimes10 07-14-2012 03:31 AM

they would be electronic with climate control. and Not ALL cars have an orfice tube and use piping diameter to get the pressure difference. look it up online for Your specific car. and yes the blockage could have moved. elevation has little effect on A/C so leave that out.

Formula413 07-14-2012 05:18 AM

I thought cars had either an orifice tube or an expansion valve but not both, is that not correct? Looking at a parts list on a Honda parts website I didn't see an orifice tube listed.

98 hoe 07-14-2012 01:31 PM

Yes it will either have an oriface tube or an expansion valve.

ILuvPizzaTimes10 07-15-2012 12:25 PM

not always the case. the ford escort say mid 90's(only one i can think of off the top of my head) ran both. certain small cars with not alot of power ran both for better pressure differance to help aid in power loss under load.

98 hoe 07-15-2012 03:44 PM

Oh ok not familliar with low horsepower shit boxes like that. Ha ha in the early 90 I was still in a walker no ac needed.

ILuvPizzaTimes10 07-16-2012 01:45 PM

hahahaha Yeah So check out your shit alex. call the dealer and ask for the part. if they say it aint got one it dont! and that sucks cuz changing the canister filter is EXPENSIVE!!!!

Formula413 07-17-2012 02:51 AM

Like I said no orifice tube listed on the Honda parts website, only an expansion valve. What is the canister filter?

ILuvPizzaTimes10 07-17-2012 02:54 AM

its in the reciver drier. that is the a/c system filter now. and they get full of shit over the years. rubber and aluminum debris. just as an orifice tube would. if it acts up again suspect that have it vacced out and then have it pulled you will see some nasty shit on the discharge side if its dirty.

"Drier or Accumulator: The drier, also known as the receiver-drier, is sort of the safety catch for your system. The compressor is only supposed to compress the gas form of your refrigerant. However, there's always a chance that some liquid could make it back that far. The drier catches this liquid before it can damage your compressor. Since even the tiniest leak or careless installation can introduce water moisture to the system, the drier absorbs this chemically, using what's called a dessicant (similar to that packet of "DO NOT EAT" that comes with electronics). The drier also has a filter that catches any gunk that might be in there."

Formula413 07-17-2012 03:14 AM

Oh ok so it's in the drier. If I had to open the system up I'd probably just replace the drier regardless, it's only like $30. The drier in that car has a pressure switch in it, it looks like you take that out and transfer it to the new drier. I might pick up a factory service manual for this car, the engine and accessories are all different from a regular Civic. Of course half the accessories aren't even there.

Edit: OEM drier is $66 but aftermarket is $20-$30

Here's a parts list:

http://www.hondacarparts.com/parts/2...iagram=4438060

ILuvPizzaTimes10 07-17-2012 03:31 AM

go OEM dont cheap it up on some china pos that wont fit and may leak.


All times are GMT. The time now is 07:15 PM.

Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.