URGENT: Transimission Trouble
 

ok I finally found a way to get my car up on jackstands, I have everything disconnected, I 'm still on a slight incline and I cannot get the transmission out of the trans am, my father and I pulled for a half hour tried different angles with the 3 ton floor jack and two people pulling at one time cant get it to budge! I've pulled transmissions at school but it was always on a lift of on a stand and never when I only have maybe a foot at the most of space to work in. I cannot get this thing to budge. Any ideas?

Well if its a m6 then make sure you have all of the top bolts out. If it is a m6 are you pulling just the trans or trying to pull the trans and bellhousing as one? Oh and use a pry bar to help. Here is my cell 5082698124. Give me a shout if ya want and maybe I can walk you through it

just the trans from the bellhousing and I don't want to mess up the bellhousing with a prybar when I have NO gap to work with. And it's a t56.

But ther are a couple spots for a pry bar to help shim it back. If ya want give me a shout

U can try pushing in the clutch peddle maybe it is hung up is it in nuetral?

did you get ALLLLL 8 bolts out? there is one up top that is very hard to see let alone get out on your back, and there are 2 steel dowels that align the tranny to the bell housing. they tend to get FROZEN in there. facing the y pipe on the drivers side there is a small indent in the tranny case good enough size for a 1/2 flat head screwdriver to fit. tap it into that opening with a small hammer. and then on the other side there is a similar in a slightly downward angle. use a pry bar on that side. AS LONG AS ALL THE BOLTS ARE OUT! you wont crack or damage the bell housing with moderate force prying it apart.

I got seven out and there is an empty hole at the very top towards the passengers side

I'll be working on my car all day tommorrow if you want to join but I'm down on the cape man

need a hand
 

well Iam only free on weekings and if i can give you a hand ill call you Adam :tard::tard::tard:

I love you guys I have the crossmember holding up the trans right now so I don't kill the engine mounts. Thanks again for everything I'll let you know how it goes tommorrow