clutch selection
Didn't know what clutch to buy when I put the car back together I was looking into the ram clutch and the spec clutchs any advise would help mild street build with a few possible track passes.
|
I know a lot of the mustang guys like the centerforce dual friction clutch
|
dual frictions are garbage, no offense josh.
i say ram vds with full sintered iron disc! haha jk what are your plans for the motor? |
Keep in mind people this is for an LT1
|
Its got a 306 cam stock bottom end with new bearings and rings lts ory ported intake 52mm tb home ported heads 1.6 rr valve springs
|
Best Consensus I've seen so far is Spec Clutches for the LT1s....
Just pick the combo that meets your HP/Usage goals. I can tell you I've got 20K+ miles on my Stage II+ and it holds like a champ with stock like drivability.:yaaaay: Since you probably have a few more HP, you may want to go to the Stage III or III+ (Plus is essentially the non-puck or easier engagement material but holds the same power level):ummdance: |
I like my spec 3. I also run an aluminum flywheel wich I DO NOT recomend. Much harsher engagement and it hits the tires a lot harder. So I say a spec billet flywheel and spec 2 plus. Strongly recomend the billet wheel. Much better surface are for clutch engagement. And the 2 plus will drive like stock won't. Be on and off like a pucked style and holds more power then you will make.
|
i have had 2 spec IIIs, a spec III+, and a monster level 3. Monster has held up the best for me, spec felt a little more towards stock but all 3 spec clutches only lasted like 15-20k and the monster has held more so far....
|
monster doesnt make LT1 clutches.
|
| All times are GMT. The time now is 02:45 PM. |
Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.