Ok, took every ground off today and scraped them all clean.
Car fired right up and ran mint. Hopped in, drove 3/4 mile up the road to dunks, sat in drive through for a few minutes, got our coffees, pulled out of lot, coughed and died again. Grrrrrr....
Couldn't get it to restart so I pushed it home, mostly down hill thank god. Scanned it again, code 42. Ign control module. Looked up the factory flow chart, have good ground, have a 2 volt reference pulse on pin b. Wiring checks good.
So, I swap out new module for old one cause now I'm grasping at straws. Car fires right up, runs mint.
For about 5-10 minutes. Then coughs dies and won't fire again. Mudule seems to be getting hot. But why? Grounds are good, voltage signals good, I'm freakin lost...
I'm beyond frustrated here, slammed the hood shut and I'm getting ready for work. Tomorrows another day. Course now I have no idea what to look for...
__________________
The fleet...
|