"get a 94-95 PCM, the part number ends in 8051. It plugs right into the same engine harness and will run the engine just fine. If you want the knock sensors to function, you need to spend 4 minutes with a soldering iron and a $1 resistor, or I'll do it for you, you just need to connect pins 21 and 22 in the blue connector on the 94-95 PCM to each other, then connect that to ground through a 2K ohm resistor...I THINK pin 1 is ground...but if it's not, there's a ground plane on the circuit board right next to the pins...96-97 LT1 is by far THE EASIEST to convert to OBD1...and the OBD1 LT1 PCM is better supported both with datalogging software and tuning software than the 96-97.
Since it's not in an OBD2 car if you swap it, you shouldn't even think twice...OBD2 cars have to have OBD2 PCM's...3rd gen's don't."
Thats exactly what he said.
Cant wait to go home and start pulling apart the caprice now! No rush on the ecu since I'm still in school down in PA. Should I bother with the knock sensor?
__________________
5.3L LSx, Fbody .500 cam, TH400, 4500 Stall, Moser 9"
|