yeah swap axles over with your backing plates. you have to remove them to swap the brakes Anyway. best thing i do is eithre mark wich way is back, up, down, or faces out on all the shit thats coming out WITH the rear end and you will need to swap over. then you will need to drop the rear cover. remove either the paddle pin or spider shaft depending on what carrier you have? if its an Auburn you will see yellow springs and it will have an 8mm(possibly7mm) bolt holing in the pin. if you have a Zexel Torsen you will hardly be able to see inside the unit and you will see a small tab on the top of what i call a paddle. its a square pin the holds the axles inplace. BE CAREFULL!!! removing this bolt. if it breaks forget it you wont get your axles out.
ok now that the pin is out. puch each axle in SLOWLY as not to ruin the seal at the end but push it in far enough to allow the c clip enough room to pop out. catch it with a magnet. and then reassemble the same way. and use either yellow or blue locktite to hold in the pin bolt. Do Not use Red. or you will break the bolt the next time you try and remove it unless you heat it with a map/propane torch.
any questions text me. 508 208 0525.
__________________
1998 Firebird:buncha parts thats used to make it go fast..... not so much anymore. 
BAAAAAA!!!!!!
|