[Camaro9969]

Well got the motor out and just as expected found one nasty spun bearing. Actually stacked on top of each other. Couple others were a little beat. So tomorrow picking up another motor found it for $300. Haven't decided if I want to just throw it back in stock bearings and all (inspired by dudeman lol) but a very frustrating thing to fail. If I had some bent rods and was on the edge i would go forged but I really am not up for spending a ton on a motor right now so I will try this next stock bottom and hope for the best. But believe me this time around either ill add meth or always run race gas when I run 12+psi and 13+° timing. Here's a few pictures