|
#3
08-16-2011, 07:29 PM
|
|||
|
|||
its not hard, pretty straight forward. youll need to have the bearings pressed on the axles, but you have to put your backing plates on the axles first. id put the 3rd member on the housing before putting the housing in the car. i used a gasket on mine with sealer on both sides and it doesnt leak. put the springs in, raise the housing up. use the shocks to hang the housing then connect the LCAs, Torque Arm, PHB.
__________________
 1999 Z28 T-Top M6 - LS6, Bolt Ons, Suspension, MWC Narrowed 9" - 415rwhp 385rwtq 10.847 @ 125.17 1989 IROC-Z H/T M5 2006 F350 SCSB 4x4 6.0L Diesel - Studs, EGR Delete, Powermax Turbo, Extreme Tuning & Exhaust - 13.23 @ 101 
|
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode